CMS-1001

2 piece kit

Resin parts

$2.00

Steering box

You’ll receive two of these GM-generic resin-cast steering housings. This  part was machined by Cody Grayland for Mark S. Gustavson’s Dream Truck², and resin cast by Copper State Models.  Illustrated installation sheet included in the kit.

Skill Level: Moderate

CMS-2001

5 piece kit

Resin & machined parts

$7.50

Master Cylinder Kit

This kit consists of the master cylinder, mounting fascia plate, and three machined parts: hex filler cap (on top), and stop light switch and hydraulic brake fitting (both of which are drilled to permit electrical wiring and hydraulic pluming lines to be installed). These parts were machined by Cody Grayland for Mark S. Gustavson’s Dream Truck², and resin cast by Copper State Models. Illustrated installation sheet included in the kit.

Skill Level: Moderate. Builder is cautioned that machined fittings are very delicate and easily lost. No free replacements are available.

CMS-2002

10 piece kit

Resin parts

$4.50

Brake Drum and Backing Plate Kit

These parts included in this kit:six resin cast Ford-stylebacking plates (we’ve included two extra backing plates because they are very delicate parts), and four Buick-style finned brake drums that will fit the Ford-style brake backing plate that are also included in this kit. These brake drums are engineered to fit our wheel kits #CWS-6001 through CWS-6004. You will need to add your own miniature bolt hardware and brake hoses/fittings. The masters for these parts were machined by Cody Grayland for Mark S. Gustavson’s Dream Truck², and resin cast by Copper State Models. Illustrated installation sheet included in the kit.

Note that these parts (particularly the backing plate) are very delicate and will require considerable care in assembly.

Skill Level: Advanced